Note, before using the driver:
Always disconnect the power before connecting the LED fixtures otherwise this will cause serious damage!
Make sure the unused outputs has been shorted with a shortcut connector before connecting the power.
Before use please check the correct dipswitch setting (See sticker on the driver).
For all CLS fixtures, the drivers must be set to 700mA. Except for the Lina High Power (HP) & Remote Phosphor (RP), drivers must be set to 500mA for these fixtures.
ATENDI AB
NÄCKROSGATAN 4
233 63 BARA
SVERIGE
INFO@ATENDI.SE
+46703690059
